PARTNER
®
Advanced Communications System Installation, Programming, and Use
Intercom Dial Tone (#309)
4-44
■ Remove hotline extensions from Night Service Group Extensions (#504), Calling Group
Extensions (#502), and Hunt Group Extensions (#505).
■ Use External Hotline (#311) to identify an extension that automatically dials a programmed
outside number when a user lifts the handset.
Programming 4
To identify a hotline extension and its alert extension:
1. Press
f00ss#603 at extension 10 or 11.
2. At the Extension: prompt, enter the hotline extension number.
3. At the Data - - - - - - - - - - - - prompt, enter the alert extension number (use 70 for the
loudspeaker paging system). A display similar to the following appears:
Internal Hotline Ext 33
Data 32
4. Do one of the following:
■ To change the hotline and alert extension numbers you just entered, repeat Steps 2 and 3.
■ To delete the existing hotline and alert extension numbers, press r.
■ To identify another hotline and alert extension pair, press n or p until the new
hotline extension number appears on the display. Then repeat Step 3.
5. Select another procedure, or exit programming mode.
Intercom Dial Tone (#309) 4
Use this feature to determine the type of dial tone that the system provides at an extension. It may
be necessary to change this setting to Machine (outside line) dial tone for an autodialing device,
such as a fax or modem, that has trouble making calls. For example, if you have a modem that
checks for outside line dial tone before dialing, use this procedure to change from Regular to
Machine dial tone.
Programming 4
To change the Intercom Dial Tone setting for an extension:
1. Press
f00ss#309 at extension 10 or 11.
2. At the Extension: prompt, enter the number of the extension to be programmed.
Use this procedure only if an autodialing device has trouble making calls.
To Next Page
Loading...
