Avaya PARTNER - Loudspeaker Paging System

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Loudspeaker Paging System
9-26
Programming 9
To identify a Fax Machine extension:
1. Press
f00ss#601 at extension 10 or 11.
2. At the Extension: prompt, enter the extension to which the fax machine is connected.
3. To assign or unassign the extension, press
D until the appropriate value appears.
■ 1 = Assigned
■ 2 = Not Assigned (the factory setting) 
4. To program another extension, press
n or p until the extension number appears
on the display. Repeat Step 3.
5. Select another procedure, or exit programming mode.
Loudspeaker Paging System 9
Loudspeaker paging systems allow you to broadcast a message over a large area. The system
supports all Avaya paging systems, including the entire PagePac line. The system also supports
most paging systems from other manufacturers when the paging systems are connected using a
paging interface device. Follow these steps to connect a paging system to a line jack on the a
PARTNER module (see Figure 9-11):
1. Insert the modular plug into an available line jack on a PARTNER module. A loudspeaker
paging system can be connected to a line jack on the following PARTNER modules:
■ PARTNER ACS R7.0 processor module
■ 308EC module
■ 362EC module
■ 400E module, 400EC module.
■ 200E module
If you connect a loudspeaker paging system from another manufacturer, a paging
interface may be required.