Upgrading the System
Changing Settings and Adding Lines, Pools, and Extensions
10-17
■ Line Ringing (Centralized Telephone Programming) to specify when the line starts ringing at
each extension that has the line
■ Line Access Restriction (#302) to limit an extension’s access to the line
■ The system automatically assigns the new line as the last line in the Automatic Line Selection
sequence. If you want to change the order, use Automatic Line Selection.
Pooled Extensions 10
You can add new lines to existing pools if your system is configured for Hybrid mode. To assign a
new line to a pooled extension as an individual line, use the features in “Key Extensions” above.
If you add an outside line to your system for use in an existing pool, use Dial Mode (#201) if the
new line is a rotary line and Pool Line Assignment (#207) to add the line to an existing pool.
Adding New Pools 10
You can create new pools if your system is operating in Hybrid mode. If you add outside lines for
use in a new pool, you may need to use the following features:
■ Dial Mode (#201) if the new lines are rotary lines
■ Pool Line Assignment (#207) to assign lines to the new pool
■ Pool Extension Assignment (#314) to assign the new pool to specific extensions
■ Line Ringing to specify when the new pool starts ringing at each extension that has the pool
■ Pool Access Restriction (#315) to limit an extension’s access to all the lines in the new pool
■ Automatic Line Selection to add the new pool to the extension’s Automatic Line Selection
sequence
Do not use Number of Lines (#104) if you add lines to the system after initial setup
because it changes Line Assignment (#301), Line Access Restriction (#302),
Automatic Line Selection, and Line Ringing for existing lines back to factory settings.
To add a new line without affecting other settings, use Line Assignment (#301).
Do not use Number of Lines (#104) if you add lines to the system after initial setup
because it changes Pool Line Assignment (#207), Pool Extension Assignment (#314),
Pool Access Restriction (#315), Automatic Line Selection, and Line Ringing for
existing pools back to factory settings. Additionally, it changes Line Assignment (#301),
Line Access Restriction (#302), Automatic Line Selection, and Line Ringing for
individual lines back to factory settings. To change pool assignments without affecting other
settings, use Pool Line Assignment (#207) and Pool Extension Assignment (#314).
To Next Page
Loading...
