Operator Features
Direct Extension Dial Features
7-13
Direct Extension Dial Delay (#112) 7
Use this feature to specify the number of times (0–9) an incoming call should ring before it is
answered by the Direct Extension Dial feature.
Considerations 7
■ This feature works independently of Line Ringing, which determines how an outside call rings
at the extension—immediately, after a 20 second delay, or not at all. Direct Extension Dial
Delay specifies the number of rings a caller hears before the system answers the call.
■ If you use Caller ID, make sure Direct Extension Dial Delay is set to 2 rings or more to
ensure that Caller ID information is captured.
■ If you use T1 lines with Direct Inward Dialing (DID) that are not administered for Direct
Inward Dialing (DID) in PARTNER ACS R7.0 PC Administration, set the number of rings to 1
ring or more.
Programming 7
To change the number of times an incoming call rings at extension 10 before the system answers
it:
1. Press
f00ss#112.
2. To change the number of rings, press
D until the appropriate value appears. Values
range from 0 to 9, where 0 means the call is answered immediately. The factory setting is 2.
3. Select another procedure, or exit programming mode.
To Next Page
Loading...
