Avaya PARTNER - Page 198

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Handling Calls
6-22
4. Press the Voice Interrupt On Busy Talk-Back button again (whether or not the originator
has hung up) to resume the conversation with the third party.
The green light next to the Voice Interrupt On Busy Talk-Back button turns off. Voice
Interrupt On Busy Talk-Back is deactivated. The originator hears two beeps if he or she
did not hang up previously.
■ To answer a coverage call:
1. If your telephone is a covering extension and it rings, check your display to see if the
ringing call is a coverage call. Also, if you have an Auto Dial button for the originating
extension, the green light next to the button flutters while the coverage call is ringing at
your extension (and it is the next ringing call you answer if you lift the handset).
2. Lift the handset.
You are connected to the coverage call.
3. The first coverage call to ring at your extension is identified in the display. If more than one
coverage call rings at your extension, you can press the Caller ID Inspect button. Then
press line, pool, or
i button next to the flashing green light to view the number of the
extension from which a coverage call is being sent.
Answering a Call on a Single-Line Telephone 6
If your single-line telephone has a button labeled “Recall” or “Flash,” use this button whenever
you are instructed to press the switchhook.
■ To answer a call:
When the telephone is ringing, lift the handset.
You are connected to the incoming call.
■ To answer a call when you are already on a call (you hear a call waiting tone—two beeps):
1. Press the switchhook.
The call you are on is placed on hold and you are connected to the new call.
2. To return to the first call, press the switchhook again.
3. You can continue to press the switchhook to move back and forth between the two calls.
You cannot transfer either party, conference in additional parties, or use feature codes
while both calls are active.