Avaya PARTNER - Page 376

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Replacing Modules
10-12
Figure 10-8. Disengaging the Mounting Tracks
If you are replacing the processor module, go to Step 7. If you are replacing the top module,
continue with Step 10.
7. Mount the new module by following the steps in “Wall-Mounting a Stand-Alone Processor
Module and a 2-Slot Carrier” on page 2-5; then go to Step 9.
8. Remove the screw at the top of the processor module, and remove the module from the wall
(see Figure 10-9).
Figure 10-9. Removing the Top Screw
9. Mount the new PARTNER ACS processor module by following the instructions in “Wall-
Mounting a Stand-Alone Processor Module and a 2-Slot Carrier” on page 2-5 and “Inserting
Batteries in the Processor Module” on page 2-11 earlier in this guide.
10. Mount or remount the top module by following the steps in “Wall-Mounting a Stand-Alone
Processor Module and a 2-Slot Carrier” on page 2-5.
Mounting
Tracks