Initial System Programming
Assigning Lines
3-13
■ To change pool assignments without affecting other settings, use Pool Line Assignment
(#207) and Pool Extension Assignment (#314).
■ In Hybrid mode, do not use this feature to add lines to the system after initial setup, because it
changes the following features for existing pools back to factory settings:
— Pool Line Assignment
— Pool Extension Assignment
— Pool Access Restriction
— Automatic Line Selection
— Line Ringing
■ In Hybrid and Key mode, do not use this feature to add lines to the system after initial setup,
because it changes the following features for individual lines back to factory settings:
— Line Assignment
— Line Access Restriction
— Automatic Line Selection
— Line Ringing
■ To change line assignments without affecting other settings, use Line Assignment (#301).
■ If your system has a 1600 DSL module, the module is automatically assigned 16 lines. If you
have less than 16 lines actually equipped for service, you may remove the unequipped line
appearances from the extension telephones by using Line Assignment (#301).
Programming 3
To assign lines to the system at initial system setup:
1. Press
f00ss#104 at extension 10 or 11.
2. Enter two digits for the number of outside lines in the system to assign to all extensions or the
main pool. For example, entering 06 means that all extensions are assigned lines 1 through
6 or lines 1 through 6 are assigned to the main pool.
3. Select another procedure, or exit programming mode.
If the Loudspeaker Paging Line was line 5, the system would assign lines 1,2,3,4,6,
and 7 to the main pool. Line 5 would be excluded because it is used for the
loudspeaker paging system.
To Next Page
Loading...
