Chapter 3: Deployment process
Deployment process
The following figure shows the deployment process for Avaya SBCE.
Figure 3: Deployment process
Deployment checklist
No.
Task Notes
1. Mount the server on an equipment rack or an electrically grounded table
top.
2. High availability requires GARP support on the connected network
elements. In scenarios where GARP is not supported, use a GARP-
aware router or switch between the elements and Avaya SBCE for the
switch to handle GARP packets sent from Avaya SBCE.
Applicable only to
multiple server HA
scenarios.
3. Connect the server to the existing network. Perform steps 3
and 4 only if the
server does not
have the software
pre-installed.
4. (Optional) Prepare the USB device or a DVD for installing Avaya SBCE. Thumb drives are
shipped separately
if ordered by the
customer.
Table continues…
August 2015 Deploying Avaya SBCE 33
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General