EasyManuals Logo

Avaya Session Border Controller for Enterprise User Manual

Avaya Session Border Controller
for Enterprise
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Chapter 7: Avaya SBCE configuration
Depending on the deployment option, perform the appropriate configuration procedure:
Single server:
- Configuring EMS and SBC on a single server on page 57
Multiple server:
- Configuring EMS on page 59
- Configuring Avaya SBCE on page 62
For multiple server configuration, the sequence must be:
1. Primary EMS
2. Secondary EMS
3. Avaya SBCE servers in any order
Configuring an EMS plus SBCE deployment
About this task
After installation, the EMS plus SBCE deployment cannot use EMS for other SBCE devices in the
network.
Procedure
1. Connect to the system using the same mode that was used for software installation. For
preinstalled servers, use the serial mode.
2. Turn on the system.
3. Wait for the configuration menu to appear.
The options are:
1-configure: Command line mode
2-configure: Text mode
3-Reboot SBCE
4-Shutdown SBCE
4. Select option 2 for text mode.
August 2015 Deploying Avaya SBCE 57
Comments on this document? infodev@avaya.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Avaya Session Border Controller for Enterprise and is the answer not in the manual?

Avaya Session Border Controller for Enterprise Specifications

General IconGeneral
BrandAvaya
ModelSession Border Controller for Enterprise
CategoryController
LanguageEnglish