7. Select Exit Saving Changes and press Enter.
8. On the confirmation screen, select yes and press Enter.
CAD 0208 (Micro SBC)
Procedure
1. Insert USB flash drive in the USB port.
2. Reboot the server.
3. If the server is connected to the VGA console, press Delete. If the server is connected to
the serial console, press Tab.
The BIOS SETUP UTILITY is started.
4. Select the Boot menu option using arrow keys.
5. Select Boot Device Priority and press Enter.
6. Select the first boot device and press Enter.
7. Select the correct USB device from the list and press Enter.
8. Press ESC to go to the Boot menu.
9. Select the Exit menu option using arrow keys.
10. Select Save Changes and Exit and press Enter.
11. Click OK and press Enter.
Installation
56 Deploying Avaya SBCE August 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General