Figure 13: Setting the code on the XT Remote Control Unit
5. Using the keypad, type the same number used in the Remote control code field.
When the code is not the default 01, the system displays the paired remote icon with its
new code at the top-right corner of the screen.
6. Select Finish in the web interface, or select OK on the endpoint.
Related links
About the XT Remote Control Unit on page 21
Accessing XT Series Web Interface
About this task
This procedure describes how to access the Avaya XT Series web interface, which supports the
following internet browsers:
• Internet Explorer version 8 or later
• Google Chrome version 11 or later
• Mozilla Firefox version 3.6 or later
• Apple Safari version 5 or later
• Opera version 11 or later
• Microsoft Edge 38 or later (EdgeHTML v14)
If you have a monitor, you can find the IP address at the top bar of the endpoint's monitor.
Before you begin
Web access is enabled by default. If it was disabled, you can enable it and configure the security
details as described in Deployment Guide for Avaya XT Series.
Procedure
1. Open any of the supported internet browsers and access the XT Series login page by
entering the system's IP address, like http://1.2.3.4/.
Controlling the XT Series
June 2019 Avaya IX Video Conferencing XT Series User Guide 27
Comments on this document? infodev@avaya.com
To Next Page
Loading...
