2. Select the required option from the Automatic answer list:
• Select Yes always for the system to automatically answer an incoming call. The system
will not prompt you to accept a call if the display shows the Home page. This is useful
for meeting rooms, where endpoints often dial in to that meeting room.
• Select Yes trusted always for the system to automatically answer incoming calls only
from trusted contacts. The system will not prompt you to accept a call if the display
shows the Home page. This is useful for meeting rooms, where endpoints often dial in to
that meeting room.
You can indicate if a contact should be trusted when you add or modify the contact’s
information (see
Finding Changing or Deleting Contacts on page 48).
• Select Never to always manually accept a call.
• Select Yes if not in a call (only XT Series with a built-in MCU) to automatically answer
when the system is not in a call. During a call, it displays an incoming call notification. If
you accept an incoming call during a call, you add the caller to your videoconference.
• Select Yes trusted if not in a call (only XT Series with a built-in MCU) to automatically
answer when the system is not in a call, for trusted contacts only. During a call, it
displays an incoming call notification. If you accept an incoming call during a call, you
add the caller to your videoconference.
You can indicate if a contact should be trusted when you add or modify the contact’s
information (see
Finding Changing or Deleting Contacts on page 48).
3. (Optional) Enter the number of rings in the Answer after (Rings) list to specify after how
many rings the system accepts a call. This option is relevant only if automatic answering is
enabled.
4. From the web interface only, select Save.
Related links
Configuring Advanced User Settings on page 90
Activating the Screen Saver
About this task
The screen saver helps protect your monitor from burn-in without switching it off.
Your administrator may have configured the screen saver to start automatically when Avaya XT
Series is not used for some time.
You can activate the screen saver at any time by pressing the
Power key on the XT Remote
Control Unit. On the Avaya XTE240, the screen saver is managed by the connected computer's
control panel.
By default, the XT Series stops sending to the monitor after 15 minutes. You can modify this in the
Monitor Turn Off field. From the XT Series web interface, select Administrator Settings > I/O
Activating the Screen Saver
June 2019 Avaya IX Video Conferencing XT Series User Guide 91
Comments on this document? infodev@avaya.com
To Next Page
Loading...
