• You can enter a service code and the XT Series is then automatically configured. This is
called auto-provisioning. If your endpoint has been pre-provisioned by your administrator, you
will receive a service code. The first time you turn on the system, you will be prompted to
insert the service code and the XT will be automatically configured, with no need to go
through the manual configuration.
The steps for both options are described here.
Related links
Getting Started on page 18
Applying the Automatic Provisioning to Avaya XT Series Endpoints on page 33
Configuring Basic Settings with the Quick Setup Wizard on page 34
Applying the Automatic Provisioning to Avaya XT Series
Endpoints
About this task
When you start the XT Series endpoints for the first time, the Quick Setup Wizard guides you
through the steps for applying the service code.
Procedure
1. Start the XT Series endpoint for the first time.
The Quick Setup Wizard is displayed.
2. Choose your preferred language and click Next.
3. Insert the service code and click Next.
You can enter a full service code, consisting of a 5-digit Server Service Code identifying
the Equinox Management server, and a 7-digit Endpoint Service Code identifying the
provisioned endpoint. Alternatively, you can enter a partial service code, consisting only of
the 5-digit Server Service Code identifying the Equinox Management server, while the 7-
digit Endpoint Service Code is either empty or consists only of zeros.
If the service code is correct and matches the value from Equinox Management, the Quick
Setup Wizard displays the name of the matching XT Series configuration. If the service
code is not correct or you do not accept the pre-configuration, you can return to the
previous step and proceed with a manual configuration. For more information, see
Configuring Basic Settings with the Quick Setup Wizard on page 34.
Applying basic settings
June 2019 Avaya IX Video Conferencing XT Series User Guide 33
Comments on this document? infodev@avaya.com
To Next Page
Loading...
