Avaya XT Series XT5000 Series XT4000 Series

To Next Page

To Previous Page

Table 6: Entering advanced call properties

Field Name Description

Call Protocol If necessary, select the protocol to use when calling another

personal endpoint or meeting room:

• Select H.323 for H.323 endpoints, such as other XT Series

endpoints, or when joining a meeting hosted by the Scopia

Elite MCU or the Equinox Conferencing Media Server.

• Select SIP for SIP endpoints.

• Select ISDN to call ISDN endpoints. This requires an ISDN

gateway such as Avaya Equinox

Gatewayfor ISDN (see

Deployment Guide for Avaya XT Series).

Call Type Select whether the call is Audio-Video or Audio-Only.

Rate or Call Rate Select the bandwidth to be used when calling a remote

endpoint. Otherwise, the system uses the maximum available

bandwidth.

Your call is securely encrypted when it shows a padlock icon on the monitor. Ask your

system administrator to configure encryption (see Deployment Guide for Avaya XT Series).

Important:

Using encryption is subject to local regulation. In some countries it is restricted or

limited for usage. For more information, consult your local reseller.

To end a meeting, select Disconnect from the web interface, or press Disconnect on

the XT Remote Control Unit.

If your system administrator defined a time limit for embedded videoconferences, the

system displays a message when the limit is reached.

Figure 26: Meeting Duration Alert

If the XT Series is participating in an Equinox Conferencing meeting where information

about the meeting and the participants are available, the XT Series displays an alert when

this meeting is going to terminate. You can decide to ignore the termination warning and

have the meeting terminate in 5 minutes or you can snooze the duration for half an hour.

Avaya XT Series XT5000 Series XT4000 Series - Page 47