Assembly
1.
Make sure the head is in the top position.
2. Make sure the crank bushing is in the center of the horizontal track on the back of the
head.
3. Make sure the crank arm pin is at top dead center.
4. Insert the motor, clutch, and crank assembly into the mount.
5. Slowly insert the assembly into the frame. You must insert the pin extending from the
crank arm into the bushing on the back of the head.
6. Press the collar into the hole in the frame.
7. Replace and tighten the four screws that hold the motor, coupling, and crank arm
assembly to the mount.
8. Connect the two wires to the power switch.
9. Replace the motor, and head assembly in the frame, then insert and tighten the four
screws that secure the mount.
10. Replace the ground wire on the motor housing.
11. Connect the motor, interlock switch, and light connectors from the circuit board.
12. Replace the enclosure and the reel support.
Crank Arm
Head Assy.
Crank
To Next Page
Loading...