22 Model E1010 Indicator User Instructions
5. Use the TARE or UNITS key to toggle between the ON and OFF choices.
Press the PRINT key when your selection is displayed…
If you choose ON go to step 5a. If you choose off, skip to step 5b.
5a. If you choose ON …
PLU 0 is displayed.
Press the PRINT key…
A numeric entry screen is displayed.
Key in a tare value for PLU 0 and press ENTER to accept it
OR
Scroll to any PLU you want by using the TARE or UNITS key, press the PRINT
key and then key in the tare value and press ENTER to accept it.
The PLU number is shown
Repeat scrolling to a PLU and entering a value until you are finished, then press
SELECT…
TARE is displayed.
5b. If you choose OFF…
TARE is displayed. With PLU tares disabled, the user can enter
keyboard or pushbutton tares during normal weighing operations.
6. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information stored for
each PLU. WARNING - Only do this if you are sure you want the
information permanently removed!
You may want to print out the reports before clearing all the information.
7. Press the PRINT key…
SURE? is displayed.
8. Press the ESC key to abort the save process or press the ENTER key to clear
all the information…
CLEAR is displayed.
9. Press the SELECT key…
PLU is displayed.
ACC (Accumulator Application
1. Press the UNITS key…
ACC. is displayed. This stands for the accumulator application.
2. Press the PRINT key…
PRINT is displayed. Use this item to print out a complete report of
accumulator totals.
To Next Page
Loading...
Need help?
General
