Model E1010 Indicator User Instructions 23
3. Press the ENTER key …
Display shows BUSY briefly then returns to PRINT.
4. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information stored for
this application. WARNING - Only do this if you are sure you want the
information permanently removed!
You may want to print out the report before clearing all the information.
5. Press the ENTER key…
SURE? is displayed.
6. Press the ESC key to abort the save process or press the ENTER key to clear
all the information…
CLEAR is displayed.
7. Press the SELECT key…
ACC. is displayed.
BATCH (Batch Application)
1. Press the UNITS key…
BATCH is displayed.
2. Press the PRINT key…
PRINT is displayed. Use this item to print out a complete report of batch
information.
3. Press the ENTER key …
Display shows BUSY briefly then returns to PRINT.
4. Press the UNITS key…
TYPE is displayed. Use this item to set the type of the batching
application to Automatic or Manual
AUTO - In this mode you start the batch by pressing the F1 key. Output
#1 activates and OP1 annunciator lights. When the weight reaches the
configured cutoff value, output #1 turns off. Output #2 automatically
activates and OP2 lights to continue the batch. This pattern repeats
through output #2 and #3.
MAN. - In manual mode, the user presses F1 to start the batching
process. As each output weight is met the output deactivates and the
user must press the F1 key to activate each subsequent output.
5. Press the PRINT key…
The current type setting is displayed.
6. Toggle between the choices by pressing the TARE or UNITS key. Press the
ENTER key when your choice is displayed…
TYPE is displayed.
To Next Page
Loading...
Need help?
General
