NOTE: When installing the H4 Multisensor surface mount camera outdoors, ensure the conduit and its
fitting are designed for outdoor use and have a suitable IP rating. Always apply silicone sealant to seal the
cable entry hole and prevent excessive moisture from entering the camera.
2. If you are using the rear cable entry hole:
a. Use the supplied mounting template to determine the cable entry location. Drill a hole in the
mounting surface and route the conduit and cables through the hole. Install the conduit and its
fitting as instructed by the manufacturer.
b. Drill 4 mounting holes as marked on the mounting template.
c. Pull the cables through the rear cable entry hole on the surface mount adapter.
Installing the Surface Mount Adapter 33
To Next Page
Loading...
