5-6
Message
LUI display
example *1
LUI display
Description and cause Action
Upper
part
Lower part
[*: Optional]
Po 2
Pressure
Sensor
Failure
AL_01
0x2*,0x3*,0x6*,0x7*
0xA*,0xb*,0xE*,0xF*
Error in the Po2 pressure
sensor.
Contact Azbil group.
Ps Pressure
Sensor
Failure
AL_01
0x4*,0x5*,0x6*,0x7*
0xc*,0xd*,0xE*,0xF*
Error in the Ps pressure
sensor.
Contact Azbil group.
Pn Pressure
Sensor
Failure
AL_01
0x8*,0x9*,0xA*,0xb*
0xc*,0xd*,0xE*,0xF*
Error in the Pn pressure
sensor.
Contact Azbil group.
Temperature
Sensor
Failure
AL_14
0x02,0x03,0x06,0x07
0x0A,0x0b,0x0E,0x0F
Temperature sensor
error.
Contact Azbil group.
Internal
Program
Execution
Error
AL_14
0x04,0x05,0x06,0x07
0x0c,0x0d,0x0E,0x0F
Program execution error. Contact Azbil group.
Local User
I/F Active
― ―
The LUI is operating (in
setup mode).
Exit the LUI setup mode
by holding down
.
Dummy
Drive Signal
simulation is
running
AL_02
0x*8,0x*9,0x*A,0x*b
The device is in the
pseudo EPM drive signal
output state.
Clear the pseudo EPM
drive signal output state.
Auto Setup
is running
AL_02 0x1*
Auto setup is being
performed.
Wait until execution ends
or stop it with the stop
command as needed.
Auto Travel
Calibration
is running
AL_02 0x2*
Automatic opening
adjustment is being
performed.
Wait until execution ends
or stop it with the stop
command as needed.
Step
Responce
Test is
running
AL_02 0x4*
The step response test is
being performed.
Wait until execution ends
or stop it with the stop
command as needed.
Valve
Signature is
running
AL_02 0x8*
Valve signature is being
performed.
Wait until execution ends
or stop it with the stop
command as needed.
VTD Angle
Span Out of
Range
AL_03
0x*1,0x*3,0x*5,0x*7
0x*9,0x*b,0x*d,0x*F
The zero and span range
is too narrow.
Adjust the zero and span
so that the angle of the
feedback lever has a
span of 4° or larger.
To Next Page
Loading...
