Azbil SDC46 - Page 23

2-15
Chapter 2. PARA BANK SETTINGS
Display Auxiliary
display
Item Settings and descriptions Initial
value
User
setting
Remarks
C-027 -
Advanced function display password 7 00000 to 0FFFF (hexadecimal value) 00000 A setting for special functions.
Normally set at 00000.
C-028 -
Advanced function display password 8
C-029 -
Advanced function display password 9
C-030 -
Advanced function display password 10
C-03 1 -
Advanced function display password 11
C-032 -
Advanced function display password 12
C-033 -
Advanced function display password 13
C-034 -
Advanced function display password 14
C-035 -
Advanced function display password 15
C-036 -
Advanced function display password 16
C-037 -
Year Cannot be set on the SDC45A/
46A/45R/46R.
C-038 -
Month, day
C-039 -
Hour, minute
C-040 -
Display brightness 0: Standard 1: Slightly dark 2: Dark 0
 Priority bank (priOr)
Display Loop number
(auxiliary display)
Item Settings and descriptions Initial
value
User
setting
Remarks
LPr.0 1 1.
SP group selection 0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.02 1.
PID group selection 0: Setting value priority
1: Internal contact input priority
2: Zone PID function priority
0
LPr.03 1.
RUN/READY mode selection 0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.04 1.
AUTO/MANUAL mode
selection
0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.05 1.
LSP/RSP mode selection 0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.06 1.
Backup/through output
mode selection
0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
Pr-0 1 1.
Release all latches 0: Setting value priority
1: Internal contact input priority
0
Pr-02 1.
OUT linearization table use
group
0: Setting value priority
1: Internal contact input priority
0
Pr-03 1.
Operation display change 0: [display] key
1: Setting value + [display] key
2: Internal contact input + [display] key
0
Pr-04 1.
Linearization table group
used for position propor-
tional control
0: Setting value priority
1: Internal contact input priority
0
LPr.0 1 2.
SP group selection 0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.02 2.
PID group selection 0: Setting value priority
1: Internal contact input priority
2: Zone PID function priority
0
LPr.03 2.
RUN/READY mode selection 0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.04 2.
AUTO/MANUAL mode
selection
0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.05 2.
LSP/RSP mode selection 0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0
LPr.06 2.
Backup/through output
mode selection
0: Setting value priority
1: Internal contact input priority
2: Later setting has priority
0