User’s Guide 2-3
4. In the DiSEqC drop-down list, select the appropriate setting for the dish antenna.
IfyouhaveonedishwithoneLNB:
Select:
None
IfyouhaveonedishwithtwoLNBs:
For each LNB/Satellite Name, select one of the following values from the pull-down list:
Simple A
Simple B
The values should match designations on your antenna hardware; consult your satellite equip-
ment provider.
If you have multiple satellite dishes:
Up to four LNBs or dish antennas can be supported. For each LNB/Satellite Name, select a DiS-
EqC designation from the pull-down list.
LOF2 L.O. (local oscillator) is 10.6 GHz (10600 MHz), so
enter 10600 in the LOF2 textbox.
Switch 11,700
Switch frequency is typically 11,700 MHz for Univer-
sal LNBs, so enter 11700 at Switch.
(Note: When you enter the Switch setting, the 22
kHz Band checkbox will disappear; the 22 kHz Band
checkbox is used only for older models of LNBs.)
Satellite DiSEqC Level 1.0 Setting
1PosA-OptA
2PosA-OptB
Table 2.2: Example DiSEqC Settings for Multiple Satellite Reception
LNB Settings Action
Table 2.1: LNB Settings Example
To Next Page
Loading...