Banner Q5X Series - TEACH (Tch2) Mode (Discrete); Two-Point Static Background Suppression (2-Pt) (Channel 2 Only)

11 © Banner Engineering Corp. www.bannerengineering.com
SENSOR PROGRAMMING
3.2.2. TEACH (tch2) Mode (Discrete)
Use this menu to select the TEACH mode. The default is two-point TEACH. Channel 2 is discrete only.
The number that follows tch on the display indicates which channel is selected.
• 2-Pt—Two-point static TEACH
• dYn—Dynamic background suppression
• FGS—One-point window (foreground suppression)
• bGS—One-point background suppression
• duAL—Dual (intensity + distance) window
After the TEACH mode is selected, from Run mode, press and hold TEACH for longer than 2 seconds to start the TEACH mode and program
the sensor.
3.2.2.1. Two-Point Static Background Suppression (2-Pt) (Channel 2 Only)
Two-point TEACH sets a single switch point. The sensor sets the switch point between two taught target distances, relative to the shifted origin
location.
Figure 5: Two-Point Static Background Suppression (Light Operate shown)
The sensor must be set to tch = 2-Pt to use the following instructions. To program the sensor using remote input, remote input must be enabled
(inPt = SEt).
1) Present the target.
2) Start the TEACH mode.
3) Teach the sensor.
4) Present the target.
Method Action Result
Push Button
Present the first target. The sensor-to-target distance must be within the sensor's
range.
The target's measurement value displays.
Remote Input
Method Action Result
Push Button Press and hold TEACH for longer than 2 seconds.
SEt and 1St flash alternately on the display.
The 1-Pt and 2-Pt indicators flash.
Remote Input No action is required. N/A
Method Action Result
Push Button Press TEACH to teach the target.
The sensor is taught the first target. SEt, 2nd,
and the current distance measurement flash
alternately on the display. The 1-Pt and 2-Pt
indicators flash.
Remote Input Single-pulse the remote input.
1
Switch
Point
Value
4
2
Press and
Hold > 2s
Press
again
3
Press
again
5
T