Banner Q5X Series - Abbreviations

© Banner Engineering Corp. www.bannerengineering.com 36
ADDITIONAL INFORMATION
Figure 2: Example mounting considerations
Figure 3: Common problems and solutions for detecting clear objects
6.4. Abbreviations
The following table describes the abbreviations used on the sensor display and in this manual.
Table 2:Sensor display definitions (Sheet 1 of 4)
Abbreviation Description
No valid signal in range
The sensor has not been taught
One-shot
CC
10° or more
Up to the maximum sensing distance
Reference Surface
Separate as far as possible
Move as close
as possible
Tilt the beam
axis downward
It can also be
tilted left or right
The object is close to the reference surface
PROBLEM:
Move the target closer to the sensor
SOLUTION:
CC CC
The sensor is far from the object
PROBLEM:
Move the sensor closer to the target
SOLUTION: