25 © Banner Engineering Corp. www.bannerengineering.com
SENSOR PROGRAMMING
3.2.17. Display View (diSP)
Use this menu to select the display view.
When the sensor is in sleep mode, the display wakes with the first button press.
1234—Normal (default setting). When 1234 is inverted, the display is in inverted view model (rotated 180°).
oFF—Normal and the display enters sleep mode after 60 seconds. When oFF is inverted, the display view is inverted (rotated 180°) and the
display enters sleep mode after 60 seconds.
3.2.18. Units (unIt)
Use this menu to set the displayed units to centimeters (cm), inches ("), millimeters (mm).
cñ—centimeter (with a decimal point at < 60 centimeters)
in—inch (with a decimal point at < 24 inches)
ññ— millimeter
3.2.19. Output Type Polarity (PoL)
Use this menu to select the output polarity.
dEF (Default)—Push-Pull IO-Link on pin 4
PnP—Solid state PNP on pin 4
nPn—Solid state NPN on pin 4
3.2.20. Exit Setup Mode (End)
Use this menu to end Setup mode.
Navigate to End and press SELECT to exit Setup mode and return to Run mode.
3.2.21. Reset to Factory Defaults (rSEt)
Use this menu to restore the sensor to the factory default settings.
no—Select to return to the sensor menu without restoring the defaults.
YES—Select to apply the factory defaults and return to Run mode.
3.2.21.1. Factory Default Settings
Table 12:Factory default settings
Setting Factory Default
TEACH Mode Two-point TEACH
Response Speed 3.0 ms
Averaging Average 1 measurement for analog output
Slope Positive slope
Zero Reference Location Zero displayed at the front of the sensor
Zero Reference Location after a TEACH Zero point is at the front of the sensor or maximum detection range
Display Units Centimeters (with decimal point at < 60 cm)
Output Type Polarity IO-Link on pin 4
Loss of Signal
3.5 mA (current models)
0 V (voltage models)
Input Wire Function Remote TEACH input inactive
Trigger Mode Average measurement
Display Read Display on
Ch2 Output Light operate
Ch2 Adaptive Tracking Adaptive tracking off
Ch2 Window Size Automatic
Ch2 Output Timing Delays No delays enabled
To Next Page
Loading...
