Banner Q5X Series - Manual Adjustments

23 © Banner Engineering Corp. www.bannerengineering.com
SENSOR PROGRAMMING
Figure 19: Hysteresis (differential travel)
Smaller hysteresis values cause the output to switch state with less differential travel. A larger hysteresis value makes the output state to remain
unchanged with larger differential travel. Negative hysteresis values allow the operator to move the hysteresis to either side of the switch point.
3.2.14. Zero Reference Location (ZEro)
Use this menu to select the zero-reference location. Changing the zero-reference location only affects the readout on the display and does not
affect the output.
The default is nEAr, 0 = the front of the sensor. This menu is not available in dual (intensity + distance) mode.
nEAr—0 is the front of the sensor and the measurement increases further from the sensor.
FAr—0 is the maximum range and the measurement increases closer to the sensor.
3.2.15. Shift the Zero Reference Location after a TEACH (ShFt)
Use this menu to select whether the sensor shifts the zero-reference location based on the last TEACH process.
The default is oFF, 0 = the front of the sensor or the maximum range. This menu is not available in dual (intensity + distance) mode.
• on—Shift the zero reference location to one of the taught positions with each TEACH
• oFF—0 = the front of the sensor or the maximum range, depending on the ZEro setting
This figure illustrates three examples of how changes to the zero and shift settings affect what distance readout is shown on the display when in
2-pt TEACH mode. Changes to the zero setting affect the direction in which the distance increases. Shifting the zero reference location only
affects the readout on the display and does not affect the output.
Sensing
Distance
Reset
Distance
Sensing
Object
OFF ON
Hysteresis