Banner Q5X Series - Trigger and Slope Settings

© Banner Engineering Corp. www.bannerengineering.com 14
SENSOR PROGRAMMING
Figure 7: One-Point Window (Foreground Suppression)
The sensor must be set to tch = FGS to use the following instructions. The FGS indicator is amber to indicate One-Point Window (Foreground
Suppression) mode. To program the sensor using remote input, remote input must be enabled (out2 = SEt).
1) Present the target.
2) Start the TEACH mode.
3) Teach the sensor.
See Typical Performance Curves on page 32 for the minimum object separation.
Method Action Result
Push Button
Present the target. The sensor-to-target distance must be within the sensor's range. The target's measurement value displays.
Remote Input
Method Action Result
Push Button Press and hold TEACH for longer than 2 seconds.
Light Operate
SEt and on flash alternately on the display.
The 1-Pt and 2-Pt indicators flash.
Dark Operate
SEt and oFF flash alternately on the display.
The 1-Pt and 2-Pt indicators flash.
Remote Input No action required. N/A
Method Action Result
Push Button Press TEACH to teach the target.
The sensor returns to Run mode.
Remote Input Single-pulse the remote input.
Table 3:Expected TEACH Behavior for One-Point Window (Foreground Suppression)
Condition TEACH Result Display
One valid TEACH point with both switch
points in range (with offset, if applicable)
Sets a window (two switch points) centered around the
taught distance. The ± window size is equal to the
non-uniform reflectivity minimum object separation. The
two switch points always stay within the specified
sensing range.
The sensor returns to Run mode.
One invalid TEACH Point
Sets a window (two switch points) centered around 150
cm. The window size is ± 10 cm.
---- and the window center point distance
flash alternately on the display.
One valid TEACH point with one switch
point within range and one switch point out
of range (with offset, if applicable)
Sets a window (two switch points) that is centered at the
TEACH point (after offset, if applicable) with one switch
point at the maximum range.
---- and the ± window size flash alternately
on the display.
One valid TEACH point that, after the
offset, results in a both switch points
outside of the range
Sets a window (two switch points) centered around 150
cm. The window size is ± 10 cm.
oFSt and the window center point distance
flash alternately on the display.
Switch
Point
Value A
Switch
Point
Value -A
1
2
Press and
Hold > 2s
Press
again
3
T