Banner Q5X Series - Page 41

© Banner Engineering Corp. www.bannerengineering.com 38
ADDITIONAL INFORMATION
Laser off
Master
Near zero reference location—the front of the sensor is 0 and the measurement increase as the target moves
further away from the sensor
Object
,
Off delay timer (Channel 1, Channel 2)
Off
,
Offset (Channel 1, Channel 2)
An applied offset resulted in an invalid switch point
On
,
On delay timer (Channel 1, Channel 2)
,
Output (Channel 1, Channel 2)
Output type polarity
Pulse frequency modulation
Reset to factory defaults
Save
Set or Input wire = remote teach function
Shift the Zero Reference Location after a TEACH
Slave
Response speed
Standard excess gain mode
Start
Stop
,
TEACH process selection (Channel 1, Channel 2)
Totalizer
Table 2:Sensor display definitions (Continued) (Sheet 3 of 4)
Abbreviation Description