Barco Coronis 5MP - Page 21

Installing a Barco display controller
21
Figure 1: Display controller VGA Jumper, VGA enabled
Note: To use multiple BarcoMed display controllers in a single
computer, you need to enable VGA on only ONE of the BarcoMed
display controllers and disable VGA on ALL the other BarcoMed
display controllers. To use a BarcoMed display controller with a
third party VGA controller or with one or more Barco MXRT display
controllers, do NOT enable VGA on the BarcoMed display controller.
Which PCI/PCIe slot to use
The table on the preceding page lists the different display
controller model(s) available for your B
ARCO CORONIS 5MP Display
System and the recommended PCI/PCIe slot to use for optimum
performance. Figure 2 shows the different types of PCIe slots that
can be used.
Figure 2: Examples of PCIe slots
Figure 3 shows the two different types of PCI slots that can be
used.
Figure 3: Examples of PCI slots
- x16 slot
- x8 slot
- x1 slot