Installing the BARCOMED CORONIS or Nio drivers and software
52
Installing the BARCOMED CORONIS or Nio drivers and software
Note: The installation dialog will display in English if your
operating system’s language is not supported.
This process applies to the following versions of Windows:
• Windows 2000 Professional,
• Windows XP Professional,
• Windows XP Professional x64 Edition,
• Windows Server 2003,
• Windows Server 2003 x64 Edition, and
• Windows Vista 32 & 64 Bit Edition.
You will need to install the Coronis 5MP system drivers and
software in the following cases:
• After you have installed the display controller(s) for your
B
ARCO CORONIS 5MP Display System in your system for the
first time.
• After you have reinstalled or upgraded your operating
system.
• After you have moved the display controller(s) to a
different PCI/PCIe slot.
1. Start your system. When the Found New Hardware Wizard
comes up, click Cancel. When the System Settings Change
window asks you to restart your computer, click No or
Restart Later.
2. Run the Barco Product Installation Wizard.
The Barco Product Installation Wizard should start
automatically if you insert the B
ARCO CORONIS 5MP Display
System Installation CD-ROM into your CD/DVD drive after the
operating system has started. If your CD/DVD drive’s auto-
run is not enabled or the Barco Product Installation Wizard
does not start automatically, you can run the Barco Product
Installation Wizard manually by following these steps:
a) Click the Start button in the task bar.
b) Click Run.
To Next Page
Loading...
