Setting the resolution of your CORONIS 5MP display
99
Setting the resolution of your CORONIS 5MP display
Note: In order to set the resolution of your CORONIS 5MP you must
be logged in using an account with administrator privileges.
Accessing the Windows Display Control Panel
1. Open the “Windows Display Control Panel” by one of the
methods below:
a) Start > Settings > Control Panel > Display
b) Open the “Display Properties Control Panel” by right
clicking in an empty area on the desktop, then select
Properties.
c) Windows Vista: Right click in an empty area on the
desktop, select “Personalization”, then click on
“Display Setting”.
2. Click on the Settings tab (the Settings tab is not present in
Vista).
3. Select the rectangle that represents the Barco display whose
settings you wish to change.
Note: If you are using the VGA capabilities of your BARCOMED
display controller, the resolution for the first display may be set
to a VGA resolution of “640 x 480” pixels with 16 colors and a
default refresh rate. If your BarcoMed controller is not running
VGA, the display may not be enabled yet. To enable the display,
check the “Extend my Windows desktop onto this monitor”
checkbox, but do NOT click the Apply button at this time.
If you installed your B
ARCO CORONIS 5MP Display System drivers in
SingleView mode (default for Windows 2000) there will be one
rectangle for the virtual display representing the two heads
controlled by each BarcoMed display controller output.
If you installed your B
ARCO CORONIS 5MP Display System drivers in
DualView mode (default for Windows XP) there will be a
rectangle representing each head controlled by each output of
the display controller. This will be true even if you have only one
To Next Page
Loading...
