Installing the BARCOMED CORONIS or Nio drivers and software
55
Note: If you installed your BARCOMED CORONIS or Nio drivers with
DualView enabled, the wizard will warn you that DualView must
be disabled before the drivers can be uninstalled. This is normal,
please follow the prompts from the wizard.
Figure 4: Barco Driver Removal Wizard
Command line (Silent) Install of Drivers and Software
(Not supported with Windows Vista)
Specifying the silent install option causes most of the GUI
associated with the installer to disappear. A background progress
window will still be visible, but no user input will be required.
The silent install behavior is dictated by the SETUP.INI file. Each
application is allowed to have separate command-line
parameters for normal and silent installs.
To install the drivers and software silently, please follow the
steps below:
1. Insert the B
ARCO CORONIS 5MP Display System Installation
CD-ROM into your CD/DVD drive. When the Barco Product
Installation Wizard starts click “Cancel”.
2. Click the Start button in the task bar.
To Next Page
Loading...
