63
Color Format
• 24-Bit TrueColor Mode
• 30-Bit TrueColor Mode (HDR)
Display Resolution
Sets display resolution for 1 or 2 displays.
Note: To switch out of SingleView or Clone mode, the buttons in
this Control Panel page must be used. The main Windows Control
Panel cannot be used. Depending on your system, certain
configurations can be disabled.
Note: Clone Mode is supported for two color displays or
projectors in 32bpp. Clone mode is not supported on grayscale
displays. Also, HDR is not supported while in Clone Mode.
When choosing Clone Mode under the Barco Adapter
Configuration page, if two displays are enabled, then the larger
of the two current resolutions will be used. If only one of the two
displays is enabled, the enabled displayís current resolution will
be used.
When the resolution set for clone mode is larger then the
maximum supported on a display, the resolution set on the
Master will automatically be scaled to maximum resolution of
the Cloned display. If the Scale to Display Preferred Mode is
checked, the maximum resolution will be the EDID preferred
mode. If it is unchecked, then it will be the largest mode in the
Cloned displays mode list. Clone mode can only be exited
through the Barco Adapter Configuration page in the Barco
Advanced Control Panel.
Note: Not all options are available at all times. Please select the
help tips in the driver software for more information.
OpenGL and Direct3D
The OpenGL and Direct3D pages of the Advanced Properties page
are divided into two sections: Main Settings and Custom Settings.
To Next Page
Loading...
