Installation
36
To remove the clip:
1. Position the display with its rear side facing you.
2. Lift up the 2 clips of the foot cover to release the cover from
the foot.
3. Pull the lower side of the cover towards you and
simultaneously slide the cover downward.
4. Pull the red clip out of the fixation holes in the foot.
You can better leave the cover off the foot while connecting the
signal cables to the display.
Portrait or landscape position
You can change the orientation of the panel at any time, but it is
more convenient to select landscape or portrait orientation
before connecting the cables.
To change the panel orientation:
1. Stand at the front side of the panel and take the panel at
both sides.
2. Very important: Tilt the panel before changing the
orientation.
To Next Page
Loading...
