Installation Procedure
22
Installation Procedure
The following instructions will take you step by step through the
installation of the display controller(s) for your B
ARCO CORONIS 5MP
Display System
Caution: Wear a grounded, protective ESD strap when handling
or during installation of the display controller. Electrostatic
charges can damage the display controller.
1. If you are not going to use your old graphics card, uninstall
the drivers and software for it if you have not already done
so.
2. Turn off the computer, display(s), and other peripheral
devices.
3. Unplug the computer’s power cord and disconnect all cables
from the back of your computer.
Caution: Wait approximately 20 seconds after unplugging the
power cord before disconnecting a peripheral or removing a
component from the motherboard to avoid possible damage to
the motherboard.
4. Remove the computer cover.
If necessary, consult your computer’s manual for help in
removing the cover.
5. If necessary, unscrew or unfasten and remove any existing
graphics card(s) from your computer.
Note: If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a multiple-
display setup, disable it either in the computer’s System Set-up
utility (BIOS) or the Windows device manager.
6. Locate the appropriate slot and, if necessary, remove the
metal back-plate cover(s).
To Next Page
Loading...
