Installation Procedure
23
7. Align the display controller(s) for your BARCO CORONIS 5MP
Display System with the slot(s) and press it(them) in firmly
until the card(s) is(are) fully seated.
Note: The next step applies only to the MXRT 5100, MXRT 7100,
and MXRT 7200.
8. Connect the power cable(s) to the 6-pin power connection(s)
on the graphics card. Make sure the cables are not
interfering with anything inside the computer (for example,
a cooling fan).
Figure 4: Power connection for the MXRT 5100, 7100, & 7300
controllers
Figure 5: Power connection for the MXRT 7200 controller
6-pin graphics controller
power cable
6-pin graphic controller
power cables - connect
2 cables as shown
To Next Page
Loading...
