Installation
39
Figure 17
1. Push the upper side of the cover onto the foot, so that the
hooks on the cover are positioned right under the holes in
the foot.
2. Slide the cover upward while moving the lower side of the
cover towards the foot.
3. Press the cover to the foot so that both clips make a clicking
sound.
Using the USB hub
The USB interface inside the display allows you to connect USB
devices, such as a keyboard, mouse or digital camera, to the
display.
To use the USB hub:
1. Connect the display’s USB upstream connector (5) to the USB
port of the PC.
2. Connect any USB device to any of the display’s USB
downstream connectors (2) or (4).
Push the upper side of
the cover onto the foot
Signal cables routed under foot
cover
Connector
compartment
To Next Page
Loading...
