Installation Procedure
24
9. Screw in or fasten the display controller securely. Replace
and secure the computer cover.
10. Connect your Coronis 5MPs to the display controller(s) for
your B
ARCO CORONIS 5MP Display System using the cables
supplied. Make sure all cables are securely connected before
turning on your system. Figures 6 - 10 show the types of
connections are available:
Connecting your Barco displays
For a detailed description of the display installation and signal
connection, please refer to the “Display installation” section of
this manual.
Figure 6
IO-Panel for the Barco MXRT 1150 and Barco MXRT 2150
X
S-Video Connection
This option is not supported by Barco.
Y
DMS-59 connector provides DVI-I / Head 1 & Head 2
output connections through included Y adaptor cable.
To Next Page
Loading...
