Installing the BARCO MXRT drivers and software
51
See figure 2 for an example of how the command line window
should look when using the silent install from the B
ARCO CORONIS
5MP Display System Installation CD-ROM.
Figure 2: Command line installation
Note: When performing an MXRT driver upgrade, it is essential to
uninstall the previous installation before installing the new
driver. We also recommend that you perfrom the following steps
to completely remove the previously installed files:
a) Boot the system in safe mode.
b) Run MXRT driver cleaner.bat by double clicking on it
(this will either be installed as an icon on your desktop,
or can be found on the Barco Display System
installation CD at: drivers\2KXP\ATI). This will remove
all the previous installed MXRT driver files.
c) Reboot the system in regular mode and install the new
driver.
To Next Page
Loading...
