Installing the BARCO MXRT drivers and software
47
The Barco Product Installation Wizard should start
automatically when you insert the B
ARCO CORONIS 5MP Display
System Installation CD-ROM into your computer’s CD/DVD
drive after the operating system has started. If your CD/DVD
drive’s auto-run is not enabled or the Barco Product
Installation Wizard does not start automatically, you can run
the Barco Product Installation Wizard manually by following
these steps:
a) Click the Start button in the task bar.
b) Click Run.
c) Click Browse and browse to the root directory of the
B
ARCO CORONIS 5MP Display System Installation CD-ROM
and click on the file, Setup.exe, and click Open.
d) Click OK.
or
a) Browse to the root directory of the B
ARCO CORONIS 5MP
Display System Installation CD-ROM and double click on
the file, Setup.exe.
3. Click Next twice.
4. Click Yes to accept the terms of the MediCal QAWeb Agent
license agreement. The Barco setup wizard will continue
with the installation only if you accept the terms of the
license agreement. If you click No, the wizard will exit. Click
Next.
5. Follow the wizard’s on-screen instructions to complete the
MediCal QAWeb installation.
6. The Barco Product Installation Wizard will now guide you
through the installation of the driver.
7. Click Yes to accept the terms of the Barco and ATI license
agreements. The Barco setup wizard will continue with the
installation only if you accept the terms of both license
agreements. If you click No, the wizard will exit. Click Next.
To Next Page
Loading...
