On-screen display (OSD)
40
Measure ALC value The value shown here is taken into
account in the calculation of the
DICOM DF if Continuous DICOM ALC
is switched off and DICOM Offset is
set to “Measured ALC”.
When you select this line and press
Enter , the actual averaged ambi-
ent light value is stored here, over-
writing the former value.
However, if the averaged ambient
light value is higher than the maxi-
mum ambient light value that cor-
responds to the selected reading
room, a warning is displayed
prompting you to dim the light in
the room, and the value will be lim-
ited to the maximum ambient light
value.
If you dim the light in the room you
can execute the Measure ALC Value
function again to enter the new,
lower value.
Name Description
To Next Page
Loading...
Need help?
General