BARCO MXRT control panel settings
8
BARCO MXRT control panel settings
This chapter describes how to configure the displays in your BARCO
C
ORONIS Display System using the tools available through the Advanced
button on the Settings tab of the Windows Display Control Panel.
Note: If you purchased Barco Medical Displays only and not a
complete B
ARCO CORONIS Display System you will need to refer to
the user manual for the display controller you are using.
Accessing the Barco tab
Note: You must have logged on to Windows using an account
with administrator privileges in order to use the Barco portions of
the Windows Display Control Panel to change any display settings.
1. Open the Windows Display Control Panel by one of the two
methods below:
a) Start > Settings > Control Panel > Display
or
b) Open the “Display Properties Control Panel” by right
clicking in an empty area on the desktop, then select
Properties.
2. Click on the Settings tab.
3. Select the rectangle that represents the Barco Coronis display
whose settings you wish to change.
4. Click on the Advanced button.
5. Select the Barco tab from the Properties screen.
Using the Barco tab
The Barco tab is divided into three sections. The first section provides
information about the graphics controller and allows access to the
graphics controller advanced configuration pages. The second section
To Next Page
Loading...
Need help?
General