R5906848 /04 DP2K SLP Series172
Full power white luminance in 3D mode and Target luminance 3D scope
The procedure is simular to one for 2D mode except the following points:
• The projector must be set in 3D mode (in Communicator, select Configuration ➙ 3D ➙ Activate 3D file and
select the corresponding 3D file for your 3D system).
• All measurements must be done with a light meter looking through a 3D glass towards the screen.
Color calibration & Light measurements
To Next Page
Loading...
Need help?
General
