R5906848 /04 DP2K SLP Series48
Image 6-5
3. Connect the two MAINS INPUT wires (reference 1 Image 6-6) and the new PE wire (Z3403519, reference 2)
with the LDM.
Image 6-6
4. Connect the LDM driver cables to the LDM (reference 3)
5. Connect the wire unit with the LDM (reference 4).
6. Install the rear cover and left side cover of the projector.
6.3 Replacing a driver board in an LDM unit
CAUTION: This procedure assumes the Laser Driver Module is removed from the projector
chassis.
This procedure follows the example of one specific driver board. This procedure is identical for
every other driver board and power module in both LDM units.
Required tools
2.5 mm Allen wrench
Laser Driver Module (LDM)
To Next Page
Loading...
