209
About this chapter
This chapter gives a brief introduction of the Card Cage, the different boards inside the Card Cage, and how to
access the Card Case and these boards. Futhermore, the board replacement and fan replacement
procedures are included as well.
WARNING: The procedures below may only be performed by Barco trained and qualified
technicians.
WARNING: Disconnect the power cord of the projector from the power net and wait a few minutes
(to discharge the capacitors) prior to starting this procedure.
CAUTION: Wear a wrist band which is connected to the ground while handling the electrostatic
discharge sensitive parts.
Overview
•
Introduction Card Cage
• Integrated Cinema Processor (ICP)
• Cinema Controller
• Replacement of the ICP board
• Replacement of the RTC battery of the ICP board
• Replacement of the HDSDI board
• Replacement of the Link Decryptor
• Replacement of the Cinema Controller
• Battery replacement on the Cinema Controller Board
• Replacement of the Card Cage small fan
• Replacement of the Card Cage large fan
• Replacement of the ICP fan
• Replacement of the Button Module
• Signal Backplane replacement process
• Removal of the Card Cage cover
• Disconnecting the Card Cage wires
• Removal of the Card Cage
• Removal of the Signal Backplane
• Installing the Signal Backplane
• Installing the Card Cage
R5906848 /04 DP2K SLP Series
Card Cage 18
To Next Page
Loading...
Need help?
General
