Barco DP2K-10SLP User Manual

R5906848 /04 DP2K SLP Series 273
1
Image 22-2
22.3 Removal of the top cover
WARNING: Switch off the projector prior to start with this procedure, unless otherwise specified in
the procedure.
To remove the top cover from the projector the Communicator Touch Panel must be removed first if
installed on top of the projector. This procedure assumes that the Communicator Touch Panel is not
installed on top of the projector.
Required tools
Flat screwdriver 7 mm
How to remove the top cover?
1. Loosen the four captive screws (reference 1 Image 22-3) of the top cover using a 7 mm flat screwdriver.
2. Remove the top cover from the projector.
1
Image 22-3
Removal and installation of the projector covers

Barco DP2K-10SLP Specifications

General

Brand	Barco
Model	DP2K-10SLP
Category	Projector
Language	English