5. Lenses & lens holder
Start the fixation as follows:
a) Turn b y hand set s crew A until you feel a small resistance ( set screw is just against the lens plate).
b) Turn nut 1 towards the p late by h and until you feel a sm all resistance.
c) W hilst checking the image to make sure no movem ent is visible, continue to turn set screw A and then nut 1, alternating
between the two, until this point is fix ed. If the image does move during adjustment you hav e gone too far and must return to
where the image is on its place a gain and repeat this pr ocedure.
11.Turn set s crew B, C and D with an Allen key. Use a bit m ore force than on set screw A but not too m uch force.
12.Secure the lock nuts a, b, c and d on the set screws.
56
R59770351 DP2K-20C 02/02/2010
To Next Page
Loading...
