R5910123 /00 FL40 / FS40 Projectors
122
13.1 Projector lenses
General guidelines for cleaning projector lenses
Blow off dust with clean compressed air (or pressurized air cans) .
Use lens cleaner and a clean lens cleaning cloth to remove the dust and contamination.
Wipe in broad strokes, in one direction only.
Warning: Do not wipe back and forwards across the lens surface as this tends to grind dirt into the coating.
Use a dry clean lens cleaning cloth to remove left liquid or stripes. Polish with small circles.
If there are still fingerprints on the surface, repeat with lens cleaner and a clean lens cleaning cloth, then polish
again with a dry cloth.
If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a dirty
cloth.
13.2 Projector cabinet
WARNING: Always disconnect the projector from the mains power net before attempting to clean
the projector cabinet.
General guidelines for cleaning the projector cabinet (exterior only)
Clean the housing of the projector with a damp cloth. Stubborn stains may be removed with a cloth lightly
dampened with a mild detergent solution.
13.3 Filters
General info
This equipment is intended to operate in a “normal” environment, without any exposure to extreme amounts of
dust or moisture. and by that also shipped without any kind filters for the air intake.
There are filters for extreme environments available, contact your dealer for more info.
User maintenance — Cleaning the projector
To Next Page
Loading...
Need help?
General
