116 LED-PRO • User’s Guide
5. Upgrading Software
Serial Upgrade Method
14. On LED-PRO, perform a factory reset. Press SETUP, select Factory Reset, and
then confirm. In Chapter 4, refer to the “Factory Reset” section on page 52 for
additional details.
15. On LED-PRO, verify that the new software has been loaded correctly. Press
SETUP, then navigate to the Software Version Menu by selecting Expert Mode
> Software Version.
Figure 5-4. Software Version Menu
This completes the software upgrade procedure.
Warning
Use caution when performing this step, as all saved files will
be erased.
SOFTWARE VERSION
Version 2.00
To Next Page
Loading...
