Barco LED-PRO - Ocrst; Ocsav

146 LED-PRO • User’s Guide
_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
LED-PRO Remote Commands
type [1-2], V Lock | HV Lock
• Query:
LCKMODE?
Returns the Lock To Source Mode and Type in the format
= mode type
S LCKMODE 1 2 (Enable Lock To Source and set Type to HV Lock)
S LCKMODE? (Queries Lock To Source Mode and Type)
i`hme^pb==Ü=
• Description: Sets Lock To Source Horizontal Phase
• Parameters: h - H Phase [ (-Input H Total/2) - (+Input H Total/2) ]
• Query:
LCKPHASE?
Returns the Lock To Source Horizontal Phase in the format
= h
S LCKPHASE 150 (Set Lock To Source H Phase to 150)
S LCKPHASE? (Queries Lock To Source H Phase)
l`kq=ååå
• Description: Adjust LED Wall Output Contrast.
• Parameters: nnn - Output Contrast (0% - 100%)
• Query:
OCNT?
Returns the Output Contrast in the format
= nnn
S OCNT 50 (Adjusts Output Contrast to 50%)
S OCNT? (Queries Output Contrast)
l`opq
• Description: Reset Output Configuration.
• Parameters: None
S OCRST (Reset Output Configuration)
l`p^s
• Description: Save Output Configuration to non-volatile memory.
• Parameters: None
S OCSAV (Save Output Configuration)
Note
Command is only applicable when LED Wall Ctrl = Local.