Barco LED-PRO - System; Diagnostic RS232; EDID DVI in Frmt; Ethernet

88 LED-PRO • User’s Guide
4. Operation
Using the Expert Mode Menu
póëíÉã
From the Expert Mode Menu, select System to display the System Menu, which enables
you to adjust a variety of system parameters, such as the display brightness, Ethernet and
Diagnostic RS-232 settings, and panel lock.
Figure 4-70. System Menu (sample)
Following are descriptions of each menu function:
• VFD Brightness
• Diagnostic RS232
• Ethernet
• EDID DVI In Frmt
• Lock Front Panel
• Save System State
• Unsaved Changes
sca=_êáÖÜíåÉëë
On the System Menu, scroll to the VFD Brightness function and press SEL to adjust the
intensity of the front panel vacuum fluorescent display (VFD). The adjustment range is -7
(dimmest) to 8 (brightest). The factory default setting is 2.
aá~ÖåçëíáÅ=opOPO
On the System Menu, select the Diagnostic RS232 function to display the Diagnostic
RS232 Menu, which enables you to set Diagnostic Port parameters.
Figure 4-71. Diagnostic RS232 Menu (sample)
SYSTEM
> VFD Brightness +2
Diagnostic RS232 >>
Ethernet >>
EDID DVI In Frmt >>
Lock Front Panel
Save System State
Tip
Whenever possible, use a low intensity setting to avoid "burn-
in" of the display.
DIAGNOSTIC RS232
> Baud 38400
Parameters N81
Handshaking On
Reset